|The Type IV modem of Dataone consists of 4 LAN ports and and a Wi-Fi router. This guide will help you to configure the modem for using DataOne Broadband in PPPoE mode, so that you dont have to wait for the lazy BSNL fellows. The guide uses Windows XP as the OS and IE (v8 RC1) as browser.|
Configuring in PPPoE Mode(Always On):
This is the mode set by BSNL fellows. If u configure BSNL modem in this mode, you can access Broadband in always on mode, i.e you can just on modem and start using internet.
1.After connecting the modem to the computer using the LAN cable, power on the modem and open Network Connections from Control Panel.
2.Right click on the icon named Local Area Connection, select properties. Select Internet Protocol(TCP/IP) and click on properties.
3.In the Internet Protocol(TCP/IP) Properties
dialog box enter the following values, after you make sure that you have selected the radio buttons, Use the following IP address
and Use the following DNS server addresses.
IP Address : 192.168.1.x(where x =2 to 255)
Subnet Mask : 255.255.255.0
Default Gateway: 192.168.1.1
Preferred DNS Server: 184.108.40.206
Alternate DNS Server: 220.127.116.11
4. Now click OK twice to close both the dialog boxes.
5. Now open your browser(preferably IE since all the BSNL sites are designed to suite IE).
in the address bar. You will be navigated to the screen below:
Enter username and password both as admin
6.Navigate to Advanced Setup->WAN
by selecting from the left margin.
Your screen should be like this.
7. Click Edit
on the service pppoe-0_35_1
If you dont have the above service in the above list, click on Add
8. Next you will be getting a series of windows, described below(irrespective of whether you click add or edit
). Click on next after each step to reach the next one.
i) ATM PVC Configuration
Enter the following values: VPI
= 0, VCI
=35 and uncheck Enable VLAN Tagging
also the Service Category
: UBR Without PCR
Select PPP over Ethernet(PPPoE)
, and Encapsulation Mode
as LLC/SNAP- BRIDGING
iii) PPP Username and Password
Enter the following details:
PPP Username: username provided by BSNL.
PPP Password: password provided by BSNL
PPPoE Service Name: DataOne
Authentication Mode: Auto
Uncheck all the check boxes except the last one(Bridge PPPoE Frames between WAN and Local Ports
iv) Network Address Translation Settings
Uncheck Enable NAT, Enable Firewall, Enable IGMP Multicast
, and check Enable WAN Service
.Service Name: pppoe_0_35_1
v) WAN Setup - Summary
You will finally get the following page:
Click on Save.
9. You will return to the WAN
Click on Save/Reebot and wait till the modem reboots and displays the Device Info->Summary
10. Restart the browser and start browsing the net.
Please pour in your queries as comments.
You can also refer this official BSNL linkVideo Tutorial
for WA3002G4, UT200R2U,DNA-A211-I (all has similar UI)
Hope you like it. Use Facebook " Like ", Twitter and + 1 buttons to share.